ABB Relion 670 Series Technical Reference Manual page 967

1MRK505222-UUS C
15.7.5
Table 592: DRPRDRE Non group settings (basic)
Name Values (Range)
Operation Disabled
Enabled
PreFaultRecT 0.05 - 9.90
PostFaultRecT 0.1 - 10.0
TimeLimit 0.5 - 10.0
PostRetrig Disabled
Enabled
ZeroAngleRef 1 - 30
OpModeTest Disabled
Enabled
Table 593: A1RADR Non group settings (basic)
Name Values (Range)
Operation01 Disabled
Enabled
NomValue01 0.0 - 999999.9
UnderTrigOp01 Disabled
Enabled
UnderTrigLe01 0 - 200
OverTrigOp01 Disabled
Enabled
OverTrigLe01 0 - 5000
Operation02 Disabled
Enabled
NomValue02 0.0 - 999999.9
UnderTrigOp02 Disabled
Enabled
UnderTrigLe02 0 - 200
Table continues on next page
Technical reference manual
Name Type
INPUT14 BOOLEAN
INPUT15 BOOLEAN
INPUT16 BOOLEAN
Setting parameters
Unit Step
- -
s 0.01
s 0.1
s 0.1
- -
Ch 1
- -
Unit Step
- -
- 0.1
- -
% 1
- -
% 1
- -
- 0.1
- -
% 1
Default Description
0 Binary channel 14
0 Binary channel 15
0 Binary channel 16
Default Description
Disabled Operation Enable/Disable
0.10 Pre-fault recording time
0.5 Post-fault recording time
1.0 Fault recording time limit
Disabled Post-fault retrig enabled (On) or not (Off)
1 Reference channel (voltage), phasors,
frequency measurement
Disabled Operation mode during test mode
Default Description
Disabled Operation On/Off
0.0 Nominal value for analog channel 1
Disabled Use under level trig for analog cha 1 (on) or
not (off)
50 Under trigger level for analog cha 1 in % of
signal
Disabled Use over level trig for analog cha 1 (on) or
not (off)
200 Over trigger level for analog cha 1 in % of signal
Disabled Operation On/Off
0.0 Nominal value for analog channel 2
Disabled Use under level trig for analog cha 2 (on) or
not (off)
50 Under trigger level for analog cha 2 in % of
signal
Section 15
Monitoring
961