ABB Relion 670 Series Technical Reference Manual page 937

1MRK505222-UUS C
15.2.6
Table 572: CNTGGIO Group settings (basic)
Name Values (Range)
Operation Disabled
Enabled
15.2.7
15.3
15.3.1
15.3.2
Technical reference manual
Setting parameters
Unit Step
- -
Technical data
Table 573: CNTGGIO technical data
Function
Counter value
Max. count up speed
Event function EVENT
Function description
Event function
Introduction
When using a Substation Automation system with LON or SPA communication, time-
tagged events can be sent at change or cyclically from the IED to the station level.
These events are created from any available signal in the IED that is connected to the
Event function (EVENT). The event function block is used for remote communication.
Analog and double indication values are also transferred through EVENT function.
Principle of operation
The main purpose of the event function (EVENT) is to generate events when the state
or value of any of the connected input signals is in a state, or is undergoing a state
transition, for which event generation is enabled.
Each EVENT function has 16 inputs INPUT1 - INPUT16. Each input can be given a
name from the Application Configuration tool. The inputs are normally used to create
single events, but are also intended for double indication events.
Default Description
Disabled Disable/Enable Operation
Range or value
0-100000
10 pulses/s (50% duty cycle)
IEC 61850 IEC 60617
identification identification
EVENT
S00946 V1 EN
Section 15
Monitoring
Accuracy
-
-
ANSI/IEEE C37.2
device number
-
931