Possibility Of Front Loader Installation; General Information - Belarus 80.1 Operation Manual

5.10 Possibility of front loader installation

5.10.1 General information

When choosing, buying and installing mounted front loaders (further in the text "load-
ers"), it is necessary to pay attention to the requirements specified in the present tractor opera-
tion manual, in particular table 5.10.1.
Table 5.10.1 – The rules on use of BELARUS-80.1/82.1/820 tractor with a loader
Name of parameter (characteristics)
Standard size of wheel tyres on which loader
installation is possible
Tyre pressure in tractor wheels
Tractor wheel track, m:
- for front wheels, not less than
- for rear wheels
Permissible load on tractor axle (considering
tractor and loader weights), kN, not more
than:
- for front axle;
- for rear axle
Tractor weight with a loader installed, kg, not
more than
Push force in cutting mode, kN, not more
than
Protection against overload in cutting mode
Speed of tractor movement with a loader in-
stalled, km/h, not more than:
- operation speed with load;
- operation speed without load;
- transport speed
Tractor ballasting with a loader installed
(when necessary)
Places of loader fastening to the tractor:
- mounting frame of the loader
- push arms of the loader
Shift-time control
(tested parameters, in addition to STM opera-
tions listed in the tractor and loader operation
manuals)
Connection of the loader hydraulic system
Recommended pressure of safety valve ad-
justment (if self-supporting hydraulic distribu-
tion valve is available in the loader kit) of the
loader hydraulic system, MPa, not more than
ATTENTION: LOADER LIFTING CAPACITY DEPENDS ON THE OVERHANG AND DE-
SIGN OF THE LOADER OPERATING PARTS, AND SPECIFICATIONS OF THE LIFTED LOAD!
Parameter (characteristics) value
BELARUS-80.1: front 9.0-R20,
and rear 15.5R38.
BELARUS -82.1: front 11.2-20(F-35), and rear
15.5R38.
BELARUS-820: front 360/70R24,
and rear 18,4R34(F-11) (i.e. tyres of basic configura-
tion or imported tyres of the same type)
Internal tyre pressure of wheels shall be set as
pressure for 30km/h speed
17.5(BELARUS 80.1),
24.0(BELARUS 82.1)
37(BELARUS 820)
6300(BELARUS 80.1),
6500(BELARUS 82.1/820)
Automatic protection in the loader's design
1. Ballast weight on rear lift linkage.
2. Water solution in rear tyres.
Front beam, side rails, coupling clutch case
Semi-axle tubes, housings of GB and rear axle
1. Tightness of fasteners of loader mounting
frame and tractor wheels.
2. Tyre pressure in tractor wheels
Tractor hydraulic outlets
269
80-0000010B OM
1800
2100
50.0
18.0
6
12
20
17.0