Belarus 80.1 Operation Manual page 284

Table 6.3.1 continued
Opera-
tion No
30 Change oil in engine crankcase
31 Drain sediment from fine fuel filter
32 Perform maintenance of alternator and starter
7)
33 Check oil level in FDA wheel gear group bodies
and FDA master drive
5)
34 Check oil level in master drive body and lower
bevel pairs of FDA wheel gear groups
35 Check/adjust service brakes control
36 Check/adjust parking brake control
1)
37 Clean filter cartridge of air pressure regulator filter
in the pneumatic system
38 1) Check pneumatic system lines for air-tightness
39 1) Check/adjust brake valve drive of pneumatic
system
40 Check all connections of air cleaner and inlet
duct for air-tightness
6)
41 Grease bushings of RLL turning shaft
42 Check oil level in transmission
1)
43 Check/adjust rear PTO control
44 Check/adjust gaps between engine valves and
rocker arms
7)
45 Check/adjust axial preload in tapered bearing of
pivot
46 11) Check/tighten HPS drop arm retaining nut
47 1) 12) Change replaceable filter cartridge of combined
HLL and HSC tank (in HLL tank)
2) 12)
48 Rinse filter cartridge of HLL tank
7)
49 Check of axial play and adjustment of tapered
bearings of wheel flange
50 1) Change oil in combined HLL and HSC tank (in
HLL tank)
2)
51 Change oil in HLL tank
52 Change oil in transmission
53 4) Rinse filter cartridge of HPS body
54 4) Change oil in HPS body
6) 13)
55 Grease bushings of front axle steering knuckles
6) 13)
56 Grease bearings of front axle hubs
5)
57 Replace oil in the FDA master drive housing, inter-
mediate support of FDA cardan drive, upper and
lower bevel pairs of FDA wheel gear groups
7)
58 Replace oil in the FDA master drive housing, inter-
mediate support of FDA cardan drive, bodies of FDA
wheel gear groups
Operation description
8-10 125 250 500 1000 2000
284
80-0000010B OM
Intervals, h
X
X
X
Х
X
X
X
X
X
X
X
X
X
X
X
Х
Х
X X
X X
X
X
X
X
X
X
X
X
X
X