Belarus 80.1 Operation Manual page 285

End of table 6.3.1
Opera-
tion No
6) 14)
59 Grease mechanism of RLL gear lifting rods
6)
60 Change grease in steering joints
61 Check / adjust pressure regulator of pneumatic
system
62 Check / tighten fastening bolts of cylinder head
63 Rinse coarse fuel filter
64 Replace fine fuel filter
65 Rinse preliminary oil filter of the engine
6) 13)
66 Grease brackets of extensible knuckles of front
axle
67 Check / tighten external threaded connections of
the tractor
68 Rinse engine cooling system and change cool-
ant
69 Check/adjust fuel pump on a stand
70 Check nozzles for injection-point pressure and
fineness of fuel atomization
71 Check/adjust fuel injection fixed advance angle
72 Adjust oil pressure in engine lubrication system
Perform maintenance of air cleaner of the diesel
73
engine
____________________________________________________________________________________________________________________________________________________
1) The operation is carried out on tractors with universal cabin (canopy frame or can-
opy base on the base of universal cabin).
2) The operation is carried out on tractors with canopy frame or canopy base on the
base of small cabin.
3) The operation is carried out once only during the first STM (after 8-10 hours),
which is performed by the customer and then every 125 hours of tractor operation.
4)
The operation shall be carried out only on tractors with HPS or HSC with HPS hous-
ing.
5)
The operation shall be carried out on BELARUS-82.1 tractor (FDA with bevel
wheel gear groups).
6)
When using grease MS-1000 TU 0254-003-45540231-99 the operation shall be
carried out less often, according to table 6.7.1.
7)
The operation shall be carried out on BELARUS-820 tractors (FDA with plane-
tary-spur wheel gear groups.
8)
Control of the internal pressure in the tractor tyres and its normalization, if need-
ed, shall be carried out each time when one mode of tractor operation is changed into
another operation mode, and when the implements and machines coupled with the trac-
tor are replaced.
9) AB inspection and maintenance shall be carried out once per 3 months, but not less
often.
10) The operation shall be carried out only on tractors with HSC or HSC with HPS
housing.
11)
The operation shall be carried out on tractors with HPS.
12)
First and second change shall be carried out in 500 hours of tractor operation. Then,
the change shall be carried out every 1000 hours of operation simultaneously with oil change.
13)
The operation shall be carried out on BELARUS 80.1 tractor (front axle).
14)
The operation shall be performed only on gear lifting rods.
Operation description
8-10 125 250 500 1000 2000
As oil pressure in engine lubri-
cation system diverges from the
norm
As it clogs
285
80-0000010B OM
Intervals, h
X
X
X
X
X
X
X
X
X
X
X
X
X