Belarus 80.1 Operation Manual page 253

1. Modification of length of upper link.
It is carried out in order to ensure equal penetration of operative parts (alignment of
running depth of operative parts located one after another along the tractor run). If the car-
riage of mounted plough reaches forward along the tractor run and the front plough body
cuts deeper than the rear one, extend the upper link; and if the front plough body cuts for a
shallower depth than the rear one, the upper link shall be shortened.
2. Modification of length of left or right lifting rod.
The modification is carried out in the following cases:
- to ensure the implement's position is in the horizontal plane;
- to ensure even depth of processing with operative parts of tractor-mounted ma-
chine across the width of cut;
3. Modification of length of both lifting rods, upper link for transport position of the
implement.
The modification is carried out in the following cases:
- to ensure the necessary road clearance;
- to ensure the sufficient safe clearance between the elements of the tractor and the
implement, excluding the contact between parts of the tractor and implements (clearance
is not less than 100 mm).
4. Modification of length of both buckles.
The modification is carried out in the following cases:
- during transportation of the implement, buckles shall be blocked for the limitation
of the implement rocking at run for the avoidance of the tractor elements damaging in case
of an accident situation;
- during operation of mounted, semi-mounted tilling machines with passively oper-
ated parts for the complete tillage (share and chisel ploughs, stubble breaking ploughs,
rippers and other implements), free movement in horizontal plane (rocking) shall be en-
sured, and the buckles shall be partially locked;
IT IS FORBIDDEN TO OFFSET THE LONGITUDINAL AXIS OF THE IMPLEMENT,
RELATIVE TO THE LONGITUDINAL AXIS OF THE TRACTOR BY MEANS OF ADJUST-
MENT OF BUCKLES.
ATTENTION: LENGTH OF THE LEFT LIFTING ROD OF THE REAR LIFT LINK-
AGE MAKES 475 MM, WHICH SHALL NOT BE CHANGED WITHOUT PARTICULAR
NEED. IT IS USUALLY THE RIGHT LIFTING ROD THAT IS LENGTH ADJUSTABLE.
WHEN THE LIFTING ROD IS USED ON THE SUSPENSION AXIS AND WHEN RE-
VERSIBLE PLOUGH IS USED THE LENGTH OF THE TWO LIFTING RODS SHALL BE
IDENTICAL!
ATTENTION: NONCOMPLIANCE WITH THE REQUIREMENTS FOR ADJUST-
MENT OF BUCKLES AND LIFTING RODS MAY RESULT IN BREAK OF BUCKLES OR
SUPPORT BRACKETS OR OTHER BREAKAGE!
ATTENTION: ESSENTIAL FEATURES AND WAYS OF ADJUSTMENT OF POSI-
TION OF THE IMPLEMENT COUPLED WITH THE HELP OF LIFT LINKAGE, ACCORD-
ING TO THE PECULIARITIES OF TECHNOLOGICAL PROCESS AND AGRO-
TECHNICAL REQUIREMENTS, ARE SPECIFIED IN OPERATIONAL DOCUMENTATION
OF SUCH IMPLEMENTS. IF THERE IS NO SUCH INFORMATION IN OPERATIONAL
DOCUMENTATION, YOU SHALL OBTAIN IT FROM THE MANUFACTURER OR SELL-
ER OF THE IMPLEMENT!
253
80-0000010B OM