Table 1.2.1 finished
Parameter
(characteristics) title
22 Working equipment:
а) rear power take-off shaft:
1) rated speed of PTO shaft
end with the continuous drive
on, min
-1
:
- position I (under the engine
crankshaft speed 2081 min
- position II (under the engine
crankshaft speed 2187 min
2) rated speed of PTO shaft
with the ground-speed drive on,
rev/meter of travel
b) side semi-continuous power
take-off shaft:
1) rated speed of PTO shaft
end (under the engine crankshaft
speed 2200 min
-1
) with gear re-
duction unit engaged, min
2) rated speed of PTO shaft
end (under the engine crankshaft
-1
speed 2200 min
) with gear re-
duction unit disengaged, min
c) rear lift linkage:
1) load capacity of rear lift link-
age on suspension axis, kg, not
less than
2) time for raising rear lift
linkage from lowermost position
into uppermost position with test
load (80050) kg on suspension
axis, under maximum engine
crankshaft speed, sec., not more
than
d) tow hitch:
1)
Engine parameters, not specified in table 1.2.1., shall correspond to 243-0000100
OM, 243C/245C-0000100 OM document.
2)
For referential use.
3)
Without a creeper.
4)
Specified depending on the configuration.
5)
Permissible deviations ± 50 kg.
80.1
-1
)
-1
)
3,44
-1
:
-1
:
In section 5 "Coupling of implements"
20
Parameter value for tractor
82.1
540
1000
3,44
571
765
3200
3
80-0000010B OM
820
3,36