Belarus 80.1 Operation Manual page 292

- remove cover 1 of oil filler neck of HPS body;
- take out mesh filler filter with oil dipstick 2 and determine the oil level;
- the oil level shall be between the upper (MAX) and lower (MIN) marks of the oil
dipstick;
- place back the mesh filter;
- if necessary, add oil up to the necessary level;
- place back cover 1 of oil filler neck of HPS body.
1 – cover of oil filler neck; 2 – mesh filler filter with oil dipstick; 3 – cover of HPS
body.
ATTENTION: DO NOT LET THE OIL LEVEL DROP BELOW THE LOWER MARK
(MIN) OF OIL DIPSTICK!
6.4.2.6 Operation 15. Check of oil level in bodies of FDA upper bevel pairs with
bevel wheel gear groups
Note – The operation shall be performed on BELARUS-82.1 tractor (FDA with bevel
wheel gear groups).
To check oil level in both bodies of upper bevel pairs 2 (Figure 6.4.9), do the follow-
ing:
- put the tractor on a flat horizontal ground, stop the engine, and brake using the
parking brake;
- turn off plugs of level/fill openings 1 of upper bevel pairs' 2 bodies;
- make sure that the oil level coincides with the lower edge of level/fill opening;
- if necessary, refill oil into the upper bevel pairs' 2 bodies;
- put back the plugs of the level/fill openings;
Figure 6.4.9 – Check of oil level in bodies of FDA upper bevel pairs with bevel
wheel gear groups
Figure 6.4.8 – Check of oil level in HPS body
1 – level/fill opening; 2 – upper bevel pair body.
292
80-0000010B OM