Belarus 80.1 Operation Manual page 256

Table 5.4.1 – Specifications of hydraulic drive of BELARUS-80.1/82.1/820 tractors
Parameter designation
1 Paired hydraulic outputs
2 Oil drain pipe for hydraulic motors (free
drain)
3 Oil consumption through hydraulic out-
puts, l/min
4 Rated minimum diameter of oil pipeline,
mm:
- oil pressure pipeline
- oil drain pipeline
- free drain
5 Hydraulic lift linkage operating pressure,
MPa
6 Safety valve activation pressure, MPa
7 Allowable extraction of hydraulic fluid
from the tank, l, not more than
8 Allowable hydrostatic power take-off
(HSPTO), kW, not more than
9 Fastening threading of fast clutches, mm:
- of oil pressure and drain lines
- of free drain of the oil line
________________________________________________________________________________________________________________________________
At rated engine speed
1)
ATTENTION: INSTALLATION OF ADDITIONAL COMPONENTS AND CHANGE
OF HYDRAULIC LIFT LINKAGE PIPELINES ROUTE IS ALLOWED ONLY UPON
AGREEMENT WITH THE MANUFACTURER OR THE DEALER!
Note – Location of hydraulic lift linkage outputs and scheme of their connection to
an external consuming system is shown in figures 2.16.3 and 2.16.5.
Parameter value (characteristic)
Side
Two pairs
-
256
80-0000010B OM
Rear
One pair
One, against order
up to 46
1)
16.0
25.0
1.0
1.0
20
-2
8.0
9.0
М201,5
М201,5