Tow Hitch Tsu-2 (Hydraulic Hook) And Combined Device Tsu-2M-02; Draulic Hook Set In The Working Position And Pendulum, Set In The Additional Position) - Belarus 80.1 Operation Manual

3.17.2 Tow hitch TSU-2 (hydraulic hook) and combined device TSU-2M-02 (with
hydraulic hook set in working position and pendulum set in additional position)
Figure 3.17.1 – The diagram of TSU-2 (hydraulic hook) and TSU-2М-02 (combined
device with hydraulic hook set in working position)
Table 3.17.1 – Basic parameters and coupling dimensions TSU-2 (hydraulic hook)
Dimension type (version)
1 Mounting location
2 Purpose
3 Peculiarities of construction
4 Distance between PTO shaft end and connect-
ing pin axis, mm
5 Vertical load in hitch point, not more, kN
6 Trailing appliance steering angle, in horizontal
plane, degrees, not less than
7 Size of hook horn sphere, mm
8 Protective device type
9 Connection point of protective device to the
tractor
10 Relative calculated value of axial forces (D),
kN, not more than
1)
Imрlement accessories
TSU-2 (hydraulic hook)
Fastening in lower and side parts of the
rear axle case
For connection and coupling of agri-
cultural trailed and semi-trailed ma-
chines with travel wheels, semi-
trailers
Hydraulic hook with control through
lift linkage, provides automatic hitch
with tow eyes of agricultural ma-
chines and semi-trailers
Safety chain (rope)
Bracket bores on tow hitch
191
80-0000010B OM
147
12
±60
47
1)
56,1