Belarus 80.1 Operation Manual page 254

Figure 5.3.1 – Rear lift linkage diagram of type LL-2
Table 5.3.1 – Basic parameters and coupling dimensions of RLL
Standard size (configuration)
of the device
1 Category (under ISO 730-1)
2 Design features
3 Purpose
4 Lower links
5 Length of lower links, mm
6 Hinge pivots width of the upper
(lower) link, mm
7 Diameter of a pin of a rear-end
hinge pivot of the upper link, mm
8 Diameter of hole of rear-end
hinge pivots of lower links, mm
9 Distance between PTO shaft
end extension face and suspen-
sion axis, mm
1)
10 Column height
11 Length of the suspension axis
along the shoulders
12 Lifting power of the device, kN
a) on the suspension point;
b) on offset of 610 mm from sus-
pension point
___________________________________________________________________
_______________________________________________________
1) Dimension refers to the implement coupled.
2)
It is not allowed to give RLL load exceeding loading of tyres specified by in-
structions set forth in subsection 4.2.8 " Selecting of optimal inner pressure in tyres
depending on operational conditions and load on tractor axles, instructions for use of
tyres."
Device consisting of three links (upper one and two
lower ones), pivot-connected with tractor;
free ends of links with hinge pivots are coupled dur-
ing implement coupling with the implement's con-
necting elements
To connect (mount) or couple agricultural mount-
ed, semi-mounted machines
Detachable, with hinge pivots (optionally: telescopic)
, mm
1)
, mm
2)
:
LL-2
(Figure 5.3.1)
Category 2
885
51 (45) under ISO 730-1
51 (38) under GOST 10677
25 under ISO 730-1
22 under GOST 10677
28.7
661
610
825
30
18
254
80-0000010B OM