Figure 4.2.12 – Positions of extensible knuckle for front wheel track formation with
HPS installed,
Figure 4.2.13 shows wheel mounting options according to diagram 1 and diagram 2.
Figure 4.2.13 – Installation options for front wheels on tractors with front non-driving axle and HPS
ATTENTION: IN EX-WORKS CONDITION, THE FRONT WHEELS ARE MOUNT-
ED FOR THE TRACK ACCORDING TO DIAGRAM 1 (FIGURE 4.2.13)!
To set the wheels for the track as per diagram 2, proceed as follows:
- dismount the wheels from axle hubs;
- re-place the wheels from one sideboard to the other by attaching them to the axle
hubs with the opposite side of the plate.
Tighten the nuts attaching the wheel to the axle hub with the torque of 200 to 250
Nꞏm.
ATTENTION: AFTER MOUNTING THE WHEELS, CHECK THE NUTS FOR
TIGHTENING AFTER THE FIRST OPERATION HOUR, AFTER 10 OPERATION HOURS
AND EVERY SUBSEQUENT 125 HOURS OF OPERATION!
ATTENTION: AFTER CHANGING THE FRONT WHEEL TRACK, CARRY OUT
CHECK AND ADJUSTMENT OF FRONT WHEEL TOE-IN. BEFORE CHECKING TOE-IN,
CONTROL AND, IF NECESSARY, ADJUST THE GAPS IN STEERING JOINTS!
DIAGRAM 1
B
C
D
E
DIAGRAM 2
235
80-0000010B OM