Lower Links; General Information; Installation In Working Position Of Crossbar And Rear Ends Of Detachable Lower Links - Belarus 80.1 Operation Manual

- when performing hauling operations and operations, when front end of the upper
link is not connected to the machine or the implement, mount the upper link of the mount-
ed implement on the lower hole of the eyebar (position "B" in figure 2.17.2 and 2.28.12).

3.16.2.4 Lower links

3.16.2.4.1 General information

On tractors "BELARUS-80.1/82.1/820" detachable standard, detachable shortened
or telescopic lower links with hinges can be mounted.
On tractors "BELARUS-80.1/82.1/820" additional axes of the lower links are mount-
ed, which can be used to perform some types of work. When shifting front ends of the low-
er links from the main axes on the additional axes of the lower links, it is necessary to re-
adjust the lengths of the lifting rods and buckles locking in transport and working position.
Mounting of the detachable shortened lower links with a length of 805 mm increases
lifting capacity of the RLL by approx. 10% with reduction of lifting height by approx. 10 %.
On the front ends of detachable links 1 (figure 3.16.10) additional point "A" is pro-
vided. When attaching the lifting rod to additional point "A" lifting capacity of the RLL in-
creases by approx. 10%.
1 – front end of the lower link; 2 – lifting rod; А – additional point of lifting rod mounting.
Figure 3.16.10 – The place of the additional point location
3.16.2.4.2 Setting in working position of crossbar and rear ends of detachable lower
links
Tractors "BELARUS-80.1/82.1/820" with detachable lower links are shipped to the cus-
tomer with a crossbar (TСУ-1Zh) and rear ends of lower links, as shown in view a) of figure
3.16.11.
To set the crossbar in working position (as shown in view б) of figure 3.16.11) perform
the following operations:
- unlock and take out eyeloops 3 (figure 3.16.11), take off crossbar 4;
- unlock and take out pins 2, take off rear ends of lower links 5;
- mount crossbar 4 on the front ends of lower links 1, as shown in view б) of figure
3.16.11), fasten it by means of eyeloops 3, pins 2 and cotter pins;
- connect limiting buckles 6 to eyeloops 3.
1 – front ends of lower links; 2 – pin; 3 – eyeloop; 4 – crossbar; 5 – rear ends of lower links;
6 – limiting buckle.
Figure 3 .16.11 – Setting of the crossbar in working position
187
80-0000010B OM