Belarus 80.1 Operation Manual page 278

6.2.2 Providing access to tractor components for maintenance service of tractor with
plastic hood 82.3-8400005.
Before starting technical maintenance, it is required to remove the monocyclone,
raise and lock hood 1 (figure 6.2.2), which is fixed at the front of the tractor by means of
hinge joints.
To remove the monocyclone, pull it upwards.
To raise hood 1, do the following:
- push the lever of lock 2 away, to release the lock off the fixture;
- raise hood 1 to extreme upper position and make sure it is securely held in the
open position: spring-loaded sector 3 shall stop center pin 4 of hood 1 in the area of upper
shaped groove of sector 3
WARNING: BEFORE STARTING TECHNICAL MAINTENANCE IN THE AREA
UNDER THE HOOD, MAKE SURE IT IS SECURELY FIXED IN THE OPEN POSITION!
To lower hood 1 do the following:
- slightly raise it to release center pin 4 from the area of upper shaped groove of
sector 3;
- push sector 3 forward along tractor movement and lower hood 1 to its lowest posi-
tion;
- press the rear side of hood 1 down until you hear a typical click (actuation of
lock 2).
When lowering hood 1 make sure the side panels of the hood have been inserted in
the area between grips 5.
1 – hood; 2 – lock; 3 – sector; 4 –center pin; 5 – grip.
Figure 6.2.2 – Diagram of the mechanism to raise, lock and lower the hood
278
80-0000010B OM