Fuses Of Dashboard Of Tractors With Canopy Frame Or Canopy Base On The Ba; Sis Of Small Cabin - Belarus 80.1 Operation Manual

Depth control can be used when coupling tractor with mounted implements with
supporting wheels. It lies in the fact that the specified cultivation depth is achieved by set-
ting the support wheel of coupled implement at a certain height.
For depth control set switch 4 (figure 2.28.12) to middle position N, after raising
the RLL in the upper most position. To raise the implement shift handle 2 (figure 2.28.11)
backwards until it stops and hold it until the end of raising, whereafter the handle has to
automatically return to neutral position "N". Lowering is done by shifting handle 2 forward
in the control area until the implement starts moving down.
Upper link 2 (figure 2.28.12) of the mounted implement shall be mounted on the
lower hole of clevis 1 (position "B" in figure 2.28.12);
When using depth control method, if mounted implement is attached to the RLL, it is
forbidden to set handle 2 into position "positive lowering" (forward until it stops). Use posi-
tion "positive lowering" only when attaching the implement to the tractor lift linkage. For
positive lowering turn handle 2 in the forward most position. After releasing it has to return
to the control area (intermediate neutral), and the RLL lowering has to stop.
Note – When the distributors Р80-3/1-222, РП70-890.1 (without draft control) are in-
stalled RLL control is done by handle of the distributor. The control rules of the RLL with the dis-
tributors Р80-3/1-222, РП70-890.1 are given in subsection 2.16.3.1.
2.28.10 Fuses of dashboard of tractors with canopy frame or canopy base on the
basis of a small cabin
Two blocks of electrical circuit cut-out fuses are built in the dashboard. To access
the fuses located in dashboard 2 (figure 2.28.13), it is necessary to open covers 1.
Figure 2.28.13 – Access to fuses, located in the dashboard
Fuses, located in the dashboard, are shown in figure 2.28.14.
1 – cover; 2 – dashboard.
Figure 2.28.14 – Fuses located in the dashboard
86
80-0000010B OM