Programming Procedure For Integrated Indicator Unit Кд8083 - Belarus 80.1 Operation Manual

In tractor operation, it is allowed to change the value of parameter "wheel rolling ra-
dius R", which is defined based on the tyres installed on the tractor by means of measuring
the distance between the wheel center and the ground.
CHANGING ENTERED VALUES OF ANY OTHER PARAMETERS (FACTORY
SETTINGS) IS PROHIBITED!
3.18.3.3 Programming procedure for integrated indicator unit КД8083
The programming order of integrated indicator КД8083 is as follows:
- remove the cover of control panel;
- press button 1 (figure 3.18.1) of the panel and hold it pressed for at least two sec-
onds;
- the digital five-digit indicator will display mode "Detailed total engine operation
time", and simultaneously, the LED next to symbol "T" will light up;
- pressing the panel's button 1 several times switches in a cycle between program-
mable parameters "T", "K1", "K2", "К3", "К4", "R", "Z1", "Z2" and again "Т";
- to enter the necessary value of a selected parameter, press button 2 of the panel,
this will activate blinking of the least significant digit (first from the right) of the indicator's
selected parameter, with the frequency 3 Hz;
- by repeated pressing of the panel's button 2 select the necessary value for the
least significant digit of the selected parameter;
- press button 1 of the panel for a short time; this will activate blinking of the second-
from-the-right digit of the digital indicator;
- by means of button 2 of the panel set the necessary value of the second-right digit
of the adjusted parameter;
- press button 1 of the panel for a short time; this will activate blinking of the third-
from-the-right digit of the digital indicator;
- by means of button 2 of the panel set the necessary value of the third-right digit of
the adjusted parameter;
- lock the entered parameter value by pressing button 1 of the panel;
- another pressing of button 1of the panel will switch to the next parameter;
- to exit the programming mode switch to mode "Detailed total engine operation
time", then press panel's button 2 and hold it for at least 2 seconds. The following will hap-
pen:
a) the digital five-digit indicator will light up readings "8.8.8.8.8" for a period of
1 to 4 seconds;
b) all LED lights of PTO scales will light up and go out;
c) all six LED lights next to symbols "T", "K", "R", "Z', "km/h" and "h" will light
up and go out. Then, only the LED next to "h" will keep glowing.
This signifies that new programming parameters have been locked and will be used
by the indicator to display information.
ATTENTION: EXITING THE PROGRAMMING MODE IN ANY OTHER WAY THAN
DESCRIBED ABOVE WILL DISCARD ALL THE ENTERED CHANGES OF PARAME-
TERS!
202
80-0000010B OM