Rear Lift Linkage; General Information - Belarus 80.1 Operation Manual

3.16 Rear lift linkage

3.16.1 General information

1 – outer lever; 2 – bracket of the turning shaft; 3 – turning shaft;
5 – brace; 6 – lower link; 7 – eye-ring; 8 – buckle; 9 – axis.
The rear lift linkage serves to attach mounted and semi-mounted agricultural ma-
chines to the tractor. Mounted machines are attached to the tractor in three points: to
hinges of the lower links and upper link. Outer levers 1, (figure 3.16.1) (left and right) are
mounted with their spline bores on shaft 3, installed in bracket 2, which is secured on the
rear axle case. Levers 1 are connected to lower links 6 by means of braces 5.
Lower links are put with the front hinges on axis 9, mounted in the holes of the rear
axle case. On the lower links there are eye-rings 7, on which by means of bolts buckles 8
are fastened. Other ends of buckles 8 are mounted with the brackets on axis 9. Tie rods
limit transverse movement of lower links in transport and working positions.
Figure 3.16.1 – Rear lift linkage
180
80-0000010B OM
4 – upper link;