Tow Hitch Tsu-2 (Autonomous Hydraulic Hook) - Belarus 80.1 Operation Manual

3.17.10 Tow hitch TSU-2 (autonomous hydraulic hook)

Figure 3.17.10 – Mounting diagram of TSU-2 (autonomous hydraulic hook)
Table 3.17.5 – Basic parameters and coupling dimensions of TSU-2 (autonomous
hydraulic hook)
Dimension type (version)
1 Mounting location
2 Purpose
3 Peculiarities of construction
4 Distance between PTO end and connecting pin
axis, mm
5 Vertical load on tow hitch in hitch point, not
more, kN
6 Trailing appliance steering angle, in horizontal
plane, degrees, not less than
7 Size of hook horn sphere, mm
8 Protective device type
9 Connection place of the protective device to the
tractor
10 Relative calculated value of axial forces (D),
kN, not more
___________________________________________________________________________________________________________
1) Implement accessory.
TSU-2 (autonomous hydraulic hook)
Fastening in the lower part of the rear
axle case and PTO cover
To connect and couple agricultural
trailed and semi-trailed machines with
travel wheels, semi-trailers
Hydraulic hook with control through
lift linkage, provides automatic hitch
with two eyes of the agricultural ma-
chines and semi-trailers
Safety chain (rope)
Bracket bores on tow hitch
199
80-0000010B OM
147
10
±60
47
1)
56,1