Supplemental Performance Characteristics; Frequency Range; Additional Error (With Open/Short Correction) - Keysight 16034H Operation Manual

Specifications and Supplemental Performance Characteristics

Supplemental Performance Characteristics

Supplemental Performance Characteristics
This section provides useful data on the 16034H. These supplemental
performance characteristics should not be considered specifications.

Frequency Range

With OPEN/SHORT correction
With OPEN/SHORT/LOAD correction

Additional Error (With OPEN/SHORT correction)

Additional errors are calculated as follows.
|Z| Measurement
Additional error Ze [%] of the |Z| measurement is calculated by substituting the
values in the table below into the following equation.
Ze [%] = ± {A + (Zs/Zx + Yo × Zx) × 100}
where
A [%]
Zs [W]
Yo [S]
Zx [W]
Zs
Yo
A
where f is frequency (MHz).
D Measurement
Additional error De of the D measurement is calculated by additional error Ze
[%] of |Z| measurement as follows.
If Dx
If 0.1 < Dx
Additional Error (Proportional Error)
Short Repeatability (Impedance)
Open Repeatability (Admittance)
Measured Value (Impedance)
0.1:

De = Ze / 100
0.5:

De = ( Ze / 100) × (1 + Dx)
3MHz

120MHz

{10 + 13 × ( f / 10 )} × 10
{5 + 500 × ( f / 10 )} × 10
0.5 × ( f / 10 )
19
-3
[]
-9
[S]
2
[%]