Table of Contents
Advertisement
CAUTION
Channel Identification Rings
To Clean the Probe
Inspecting the Probe
Keysight N2818/9A Differential Probes User Guide
Always wear an ESD wrist strap when working with active probes. Not
doing so can result in the probe becoming permanently damaged.
When multiple probes are connected to the oscilloscope, use the channel
identification rings to associate the channel inputs with each probe. Place
one colored ring near the probe's channel connector and place an identical
color ring near the probe head.
Disconnect the probe from the oscilloscope and clean the probe with a soft
cloth dampened with a mild soap and water solution. Make sure that the
probe is completely dry before reconnecting it to an oscilloscope. Avoid
using abrasive cleaners and chemicals containing benzene or similar
solvents.
•
Inspect the shipping container for damage.
Keep the damaged shipping container or cushioning material until the
contents of the shipment have been checked for completeness and the
probe has been checked mechanically and electrically.
•
Check the accessories.
•
If the contents are incomplete or damaged, notify your Keysight
Technologies Sales Office.
•
Inspect the probe. If there is mechanical damage or defect, or if the
probe does not operate properly, notify your Keysight Technologies
Sales Office.
If the shipping container is damaged, or the cushioning materials show
signs of stress, notify the carrier as well as your Keysight Technologies
Sales Office. Keep the shipping materials for the carrier's inspection. The
Keysight Technologies office will arrange for repair or replacement at
Keysight Technologies' option without waiting for claim settlement.
Using the Probe
7
Advertisement
Table of Contents
