Customer Replaceable Units
5. Slide the rear top cover back and remove it from the printer. See
Installing the Rear Top Cover
1. Align the rear top cover with its mounting holes (2) in the cross bar.
2. Using a 2.5 mm hex wrench, install the screws (2) that secure the rear top cover to the
cross bar. See
3. Close the front top cover.
4. Close the oven door.
3.3/5/12 VDC ATX Power Supply
Required Tools
•
3mm hex wrench
Removing the 3.3/5/12 VDC ATX Power Supply
1. Power OFF the printer, see
2. Remove the rear panel, see
3. Disconnect the input power cable from the power supply.
4. Disconnect the power supply cables from the I/O board (J16, J19, J20, J29).
5. Using a 3mm hex wrench, remove the power supply bracket mounting screw. See
Figure
6. Pivot and lift the bracket slightly to remove the power supply from the electronics bay.
Figure 27: Rear top cover removal
Figure
27.
"Powering Off" (page
28.
© Copyright 2021 Stratasys. All rights reserved.
181).
"Removing the Rear Panel" (page
3.3/5/12 VDC ATX Power Supply
Figure
27.
182).
Page 186