Operation Panel Unit; Preparation For Removing The Control Panel; Removing The Control Panel; Dc Controller Pcb - Canon i-SENSYS LBP5300 Series Service Manual

Proper alignment appears as shown in the picture below where the
elongate holes of the gear [1] and [2] and the plate are aligned in a
straight line.
8) Attach the plate [1].
- 3 screws [2]
9) Tighten all the way the screw [3] that has been tightened halfway.

3.1.7 Operation Panel Unit

3.1.7.1 Preparation for Removing the Control Panel

/ i-SENSYS LBP5360 / i-SENSYS LBP5300
1) Detach the rear cover. (page 3-1)[Removing the Rear Cover]
2) Remove the fixing assembly. (page
Assembly]
3) Detach the upper cover. (page 3-2)[Removing the Upper Cover]
4) Detach the left cover. (page 3-1)[Removing the Left Cover]

3.1.7.2 Removing the Control Panel

/ i-SENSYS LBP5360 / i-SENSYS LBP5300
1) Remove the cable guide [1].
- 1 claw [2]
2) Disconnect the connector [3].
F-3-47
F-3-48
F-3-49
3-25)[Removing the Fixing
3) Remove the control panel [1].
- 2 screws [2]

3.1.8 DC Controller PCB

3.1.8.1 Before Removing the DC Controller PCB

/ i-SENSYS LBP5360 / i-SENSYS LBP5300
1) Remove the fixing unit. (page 3-25)[Removing the Fixing unit]
2) Remove the network board. (page
Interface Board]
3) Remove the rear cover. (page 3-1)[Removing the Rear Cover]
4) Remove the upper cover. (page 3-2)[Removing the Upper Cover]
5) Remove the right cover. (page 3-1)[Removing the Right Cover]
6) Remove the left cover. (page 3-1)[Removing the Left Cover]
7) Remove the video controller PCB. (page 3-8)[Removing the Video
Controller PCB]

3.1.8.2 Preparation for Removing the DC Controller PCB

/ i-SENSYS LBP5360
1) Detach the rear cover. (page 3-1)[Removing the Rear Cover]
2) Remove the fixing assembly. (page
Assembly]
3) Detach the upper cover. (page 3-2)[Removing the Upper Cover]
4) Detach the right cover. (page 3-1)[Removing the Right Cover]
0013-9925
5) Remove the video controller PCB. (page 3-8)[Removing the Video
Controller PCB]

3.1.8.3 Removing the DC Controller PCB

/ i-SENSYS LBP5360 / i-SENSYS LBP5300
1) Disconnect all the connectors and flat cables [2] from the DC Controller
PCB [1].
0013-9926
2) Remove the test print button guide [1].
- 4 claws [2]
Chapter 3
F-3-50
F-3-51
3-10)[Removing the Network
3-25)[Removing the Fixing
F-3-52
0013-9928
0014-8698
0013-9929
3-7