Table of Contents
Advertisement
CHAPTER 5 MECHANICAL SYSTEM
2.2.4
Removing the DC Controller PCB/Power Supply PCB
1) Remove the rear cover. (See 2.1.1.1
"Removing the Rear Cover")
2) Remove the delivery cover. (See 2.1.1.4
"Removing the Delivery Cover")
3) Disconnect the 4 connectors [1] used to
connect the image processor PCB and
the power supply unit.
4) Disconnect the connector [2] used to
connect the NCU PCB and the power
supply unit.
5) Disconnect the connector [3], and free
the harness [4] from the harness guide
[5].
6) Disconnect the 3 connectors [6].
5-20
COPYRIGHT © 2001 CANON INC.
Chapter5.p65
[3]
CANON imageCLASS D600s/PC1060s/PC1200s/iR1200s REV. 0 SEPT. 2001
20
[1]
[4]
[5]
[4]
F05-202-09
[6]
[6]
[6]
F05-202-10
8/26/01, 3:46 PM
[2]
Advertisement
Table of Contents
Troubleshooting
