Advertisement
3-26
SURE-GRIP DIFFERENTIAL
CLUTCH
PLATES
SIDE G E A R
RETAINER
I
KR720
A
Fig. 67-Removing
or Installing Clutch Plates (Cap Side)
Disassembly
(1) Remove the axle drive gear. Measure the run-
out
of
the drive gear mounting flange. Replace both
case halves
if
runout exceeds .003 inch.
NOTE:
Before disassembling the case halves, place
scribe marks on each half to aid in aligning the
case when reassembling (Fig.
65).
(2) Remove the case cap attaching bolts and
re-
move the case cap (Fig. 66) and clutch plates (Fig. 67).
(3) Remove the side gear retainer (Fig. 68), and the
side gear (Fig. 69).
(4) Remove the pinion shafts with pinion gears
(Fig. 70).
(5)
Remove the remaining side gear (Fig. 71) side
gear retainer (Fig. 72) and clutch plates (Fig. 73).
(6) Remove the axle shaft thrust spacer by press-
ing out the lock pin.
G E A R
- - - -
KR721
Fig. 68-Removing
or Installing Side Gear Retainer
'Cap
Fidel
KR722
--
"-
.-/
Fig. 69-Removing
Side Gear (Cap Side]
PINION.
GEARS
I
L ,
/
/*
1
/
KR 723
AXLE S
THRUST
W A L t K
Fig. 7 L R e m o v i n g Pinion Shafts and Gears
Fig. 71-Removing
or Installing Side Gear From
Differential Case
Hide quick links:
Advertisement
