Advertisement
TRANSMISSION-TORQUEFLITE
2 1-65
NK334
Fig. 36-Throttle
linkage Adjustment-Model
AV-1 with
170
or
225
Cu. In.
Eng.
position of the cable housing ferrule [13] in the clamp
so that all slack
is removed from the cable with the
carburetor at curb idle. To remove slack from the
cable, move the ferrule [13] in the clamp in the direc-
tion
away
from the carburetor lever.
(4) Back off ferrule [13]
y4
inch. This provides
y4
inch cable slack at idle. Tighten cable clamp nut [12].
(5) Connect choke rod [7]
or remove blocking
fix-
ture.
Automatic Transmission Fig.
36)
(Model AV-I with I 7 0 or
225
Cu. In. Eng.)
(1) Apply a thin film of multi-purpose grease on the
outside surface of carburetor lever isolator [l], and
torque shaft plastic bushing [2], also the torque shaft
ball stud [3] and bellcrank pin [lo].
(2) Disconnect the transmission intermediate rod
ball socket [5] from the bellcrank ball end.
(3) Disconnect choke at carburetor [4] or block
choke valve in full open position. Open throttle
slightly to release fast idle cam, then return throttle
to curb idle.
(4) Loosen lock nut [8] in the transmission rod, in-
sert a
inch diameter rod [7] approximately [4]
inches long in the holes provided in the transmission
rod bellcrank bracket and lever assembly.
(5)
Move the transmission lever [9] forward against
the stop and tighten the transmission rod lock nut [8].
(6) Disconnect the top end of the accelerator pedal
rod [6]. Adjust the length of this rod to provide a ped-
al angle of 111" to 113". To increase pedal angle, in-
crease the length of this rod by means of the screw
adjustment. Reinstall the top end of the rod [6].
inch diameter rod [7] from the
transmission rod bracket and lever assembly. Adjust
the length of the transmission bellcrank to torque
shaft rod by means of the screw adjustment at top
end. The correct rod length allows the ball socket to
line up with the ball end when the rod is held up-
ward against the transmission stop.
(8) Install the ball socket on torque shaft lever ball
end
[5].
(9) Connect choke rod [4]
or remove blocking
fix-
ture.
(7)
Remove the
Manual Transmission Wig.
36)
IModel AV-I With I 7 0 or
225
Cu. In. Eng.1
(1) Apply a thin film of multi-purpose grease on the
outside surface of carburetor lever isolator [l], and
torque shaft plastic bushing [2], also the torque shaft
ball stud [3].
(2) Disconnect choke at carburetor [4]
or block
choke valve in full open position. Open throttle
slightly to release fast idle cam, then return throttle
to curb idle.
Hide quick links:
Advertisement
