Plymouth Valiant V-100 1965 Service – Technical Manual page 225

WINDSHIELD WIPER SYSTEM 8-8 1
_ F
/
END
PLAY
ADJUSTMENT SCREW
\
62
x
307
Fig. 5-End Play Adjustment
END PLAY ADJUSTMENT
To adjust the armature shaft end play, turn the ad-
justment screw in until it bottoms and back-off Ys
turn (Fig. 5).
WIPER LINKS
Models AV-7, AV-2, AR-J and AR-2
Disassembly
arm.
(1)
Remove the clip holding the link to the crank
(2)
Remove the bevel washers and link.
(3)
Remove the parking cam and spring release
(Variable Speed).
(4)
Remove the
(Variable Speed).
(5) On Models
coil spring by spreading the ends
AR-1 and AR-2 disassemble the
'LINK SPRING
TRIP INTERMEDIATE
\
CRANK A R M
LINK SPRING NK1196
INTERMEDIATE
CRANK A R M
\
RIGHT
LINK
PARKING
CAM
(ECCENTRIC)
N
K1197
Fig. 7-Link Arm Installed (Variable
Speed) Models AR-7 and AR-2
right-hand link in the same manner after removing
the crank arm to lever nut and the spacing washers
between the link crank arm and lever.
Assembly
Variable Speed
Models AR-J and
aR-2
(1)
Install the spring washer, concave surface to-
ward crank arm. Install the spring on the pin of the
crank arm. Install the spring trip.
(2)
Install the parking cam to index with the spring
release and engage the spring ends, between the re-
lease and parking cam in the openings at point of in-
dex (Fig.
6).
If the intermediate crank is held so that the letter
"L" can be seen from this position, the opposite side
will show three letters "R" (Fig. 7 ) .
(3) Install the left link arm with the spring trip
on
SPRING WASHER
PARKING C A M
PARKING SPRING
/
Fig. '.Link Spring Trip Installed (Variable
Speed) Models AR-7 and AR-2
Fig. 8 V a r i a b I e Speed Parking Mechanism-
Models AV-7 and AV-2