Plymouth Valiant V-100 1965 Service – Technical Manual page 629

GLASS 23-59
(7)
Install the water shield, trim panel and regulator
handle.
Stabilizer Channel IAP Models)
The quarter glass stabilizer channel assembly is at-
tached to the quarter inner panel at the upper end
and to the side sill outer panel and reinforcement at
the lower end (Fig. 129). The adjusting stud at the
upper end of the stabilizer allows in and out move-
ment to position the top edge of the glass against the
cat whiskers. The attachment at the lower end permits
in and out adjustment.
Quarter Window Glass Track
Removal IAR-AV Models)
(1) Remove the rear seat cushion, seat back, trim
panel and water shield.
(2) With the window in the down position, remove
the retaining clips from the studs of the lower frame.
(3) Disengage the glass from the lower frame and
remove the glass from the quarter panel.
(4)
Raise the lower frame and rollers and disen-
gage the regulator arms from the frame.
(5) Pull the frame up off of the track.
(6) Scribe aligning marks on the lower track brack-
(7) Remove the track upper sleeve nuts and remove
ets and remove the lower track attaching screws.
the tracks from the quarter panel.
lnstallation
(1)
Position the tracks down in the quarter panel.
(2) Align the lower attaching screw scribe marks
(3) Install the upper track attaching nuts.
(4)
Lubricate the track and rollers and engage the
(5) Engage the frame and roller assembly to the
and install the screws.
lower frame and rollers on the track.
regulator arms.
6 ,
-STUD
\
ADJUSTING
Fig. 7 2 9 4 u a r t e r Window Stabilizer-
Convertible fAP Models)
/GLASS
I N AND OUT
I N AND OUT
I N
AND OUT
PARALLEL
KDJUSTMENT
N K944
Fig. 130-Tail Gate Glass Adjustments
(6) Place the frame and roller assembly in the down
(7) Lower the glass and install
it
on the studs of
( 8 )
Install new retaining clips on the studs.
(9) Adjust the glass and track.
(10) Install the water shield, trim panel, escutch-
eon handle, arm rest, seat back and seat cushions.
positions.
the lower frame.
TAIL GATE
Adjust ments
points.
Refer to Figure 130 for the tail gate glass adjusting
(1) Remove the tail gate trim panel and loosen the
LUBRICANT/%
/
GLASS AND FRAME N K943
Fig. 731-Tail Gate Glass Replacement fAP Models)