Advertisement
(1) Remove the inside handles, door trim panel and
water shield.
(2)
Lower the door glass fully and remove approxi-
mately four
(4)
inches of the glass run at the forward
end (Fig. 69).
(3) Remove the screws attaching the vent wing to
the end facing of the door and to the belt line.
(4)
Move the glass forward and disengage the regu-
lator arm from the lift bracket and guide assembly.
(5)
Remove the screw attaching the vent wing swiv-
el to the vent wing regulator (Fig. 69).
(6) Remove the glass and vent wing assembly from
the door.
(7)
Remove the cotter pin from the lower end of
the division channel (Fig.
70)
and separate the door
glass and vent wing assembly.
( 8 )
Remove the plastic rivet attaching the lift
bracket and guide assembly to the glass and remove
the assembly (Fig.
70).
Installation
(1)
Position the lift bracket and gasket on the door
glass and install the retaining rivet (Fig.
70).
(2)
Assemble the door glass to the vent wing as-
sembly and install the cotter pin at the lower end of
the division channel.
(3) Lubricate the sliding surfaces of the lift brack-
et.
(4)
With the regulator in the fully down position,
install the vent wing and door glass assembly into
the door and position the vent wing pivot swivel as-
sembly into the vent wing regulator.
(5)
Position the regulator arm roller into the glass
lift bracket and move the glass rearward into the
glass run channel.
(6) Install the ventilator attaching screws at the
face and belt line areas of the door.
(7)
Install the vent wing pivot swivel to regulator
screw.
LIFT BRACKET
'COTTER
PIN
G A ~ K E T
NK871
NK870
Fig. 71-Front
Door Regulator IAP Models)
(8)
Install the front end of the glass run at the for-
(9) Adjust the door glass and test
for
ease of oper-
(10) Install the water shield, trim panels and inside
ward end.
ation.
handles.
Regulator Assembly Replacement
Door Glass IAP Models)
The regulator assemblies are attached to the door
inner panels by screw and washer assemblies (Fig.
71). When removing a regulator, the door glass should
be fully lowered. Slide the regulator rearward to dis-
engage it from the lift bracket and guide assembly.
Lubricate the tooth area of the regulator when rein-
stalling.
I
Vent Wing)
The vent wing regulator is attached to the door in-
ner panel by three screw and washer assemblies and
to the
Glass
The
pivot swivel assembly by one screw (Fig. 69).
Run und Channel
glass run (Fig.
72)
is a press fit in the door
Fig. 7 L G l a s s Lift Bracket IAP Models)
Fig. 72-Glass
Run and Channel IAP Models)
Hide quick links:
Advertisement
