Advertisement
23-44
GLASS
DIVISION CHANNEL
ASSEMBLY
GLASS RUN
WEATHERSTRIP
SCREW AND WASH
6 4 x 3 9 0
Fig. 9 S - R e a r Door Stationary Glass
weatherstrip and replace if necessary.
Make sure
it
is fully installed.
(2) Slide the stationary glass into the weatherstrip.
(3)
Install the division bar and adjust as necessary.
(4)
Install the water shield, trim panel and hard-
ware.
Rear
Door
Glass Run
The glass run (Fig.
96)
is a press
fit
into the door
panel. When installing the glass run, the index point
notch should be installed first to assure correct align-
ment of the run.
FRONT DOOR GLASS
(Hard Top-Convertible)
Adjustments (AP Models)
Refer to Figure
97
for the adjusting points and
methods of adjustment for the vent wing and door
glass assembly.
SECTION A-A
(1) Open the door and run the window approxi-
mately two-thirds the way up.
(2)
Adjust the upper attachment of the rear run
channel so the window is centered between the in-
ner and outer cat whiskers.
(3) Close the door and loosen the vent wing belt
line screws. Run the window completely up and tight-
en the belt line screws.
(4)
Adjust the vent wing leg
so
the boss of the ad-
justing stud is against the support and the top of the
vent wing and door glass are inboard against the roof
rail weatherstrip.
(5) Position the up stop down against the regulator
arm.
(6)
Adjust the vent wing division bar attachment
at the bottom to allow alignment with the glass.
(7)
With the door open, run the glass half way down.
(8)
Adjust the rear lower track attachment to al-
low alignment with the glass.
(9) Run the glass down
so the top of the glass is
even with or slightly below the belt line of the door
outerpanel.
(10)
On manually operated windows, position the
stop on the regulator plate against the stop on the
regulator sector.
(1 1)
On electrically operated windows, reach
through the major access hole and position the glass
lower frame stop against the bumper.
(12) Operate the window for ease of operation
and inspect alignment.
(AR
Models)
Refer to Figure
98
for the adjustment points and
methods of adjustment for the door and vent wing
assembly.
Vent Wing fAV Models)
The two vent frame adjustments (Fig. 99) near the
IN AND OUT
FORE AND AFT
NK886
.ASS FRAME
STOP
AND OUT
AND OUT
!/
NK859
Fig. 9 6 R e a r Door Glass Run IAP Models)
Fig. 97-Front
Door
Glass Adlusting Points-
Hard Top-Convertible IAP Models)
Hide quick links:
Advertisement
