Advertisement
23-62
GLASS
the stud on the hinge reinforcement and install the
washer and nut finger tight only.
(3) Install the upper bracket retaining screw and
washer finger tight only.
(4)
Install the tailgate glass assembly and adjust the
assembly.
Upper Run Retainer und Seul
Removul fAP Models1
(1) Remove the five screws attaching the glass run
retainer to the roof rear header and remove the
re-
tainer (Fig. 138).
(2) Remove the seal assembly from the roof rear
header.
(3) Remove the headlining rear corner retainer, if
necessary.
(4)
Remove the roof headlining rear retainer from
the roof panel rear header outer reinforcement, if
necessary.
installation
(1) Position the roof headlining rear retainer to the
roof panel rear header outer reinforcement if removed
and install the two retaining screws.
(2) Install the roof headlining rear corner retainer
over the end of the headlining retainer, if removed,
and install the retainer screw.
(3) Using a new glass run retainer seal, start at the
lower edge of the upper pillar and apply the seal up
and across the roof header and down the opposite
pillar.
(4)
Position the roof rear header tailgate glass run
retainer on the seal and install the retaining screws.
Upper Run und Pillar Run
Removal fAP Models)
(1) Remove the upper run from the run retainer (a
HEADLINING REAR RETAINER
HEADLINING REAR
\
.
'-
SCREW
GLASS RUN RETAINER
f i g . 138--fatlgate
Upper Run Retainer and
Seal IAP ModelsJ
VIEW AT ARROW
Fig. 139-Tailgate
Upper Run and Pillar Run
IAP Models)
press fit into retainer) (Fig. 139).
(2) Remove the screw attaching the pillar run to the
upper end of the tailgate lower opening weatherstrip.
(3) Remove the three screws attaching the pillar
run and retainer to the pillar and remove the run
and retainer assembly.
Instullution
(1) Position the pillar glass run and retainer on
the pillar, inserting the upper end into the end of
the roof header glass run retainer and install the three
retaining screws.
(2) Install the screw attaching the lower end
of the
retainer over the lower opening weatherstrip.
(3) Starting at the center line of the
roof rear
header glass run retainer, install the upper run by
pressing it into the retainer.
(4)
Adjust the pillar glass
runs
as necessary.
Fig. 14O-Cowl
Grille Panel IAP Models)
Hide quick links:
Advertisement
