Plymouth Valiant V-100 1965 Service – Technical Manual page 636

23-66 GLASS
WEATHERSTRI P
'
'
SEALER
NK9V
Fig. 745-Rear Window Installation IAP Models)
(6) Seat the glass in the weatherstrip using hand
pressure.
(7) Apply a 3h inch bead of sealer (Fig.
145)
across
the full width and up the sides to the lower portion
of the weatherstrip and fence at the top corners.
(8) Remove all excess sealer and cement from the
glass.
(9) Water test the rear window area.
(10)
Install the inside garnish mouldings and the
(11) Remove the protective covering from the rear
outside moulding.
of the vehicle.
Removal
fAR
Models Except Two
Door
Hard
Top)
(1)
Cover the rear deck, rear window and quarter
panel areas with protective covering.
(2) Remove the chrome moulding end and center
caps.
(3)
Remove the side, lower and top weatherstrip
mouldings.
(4)
Use a fibre wedge to unlock the weatherstrip.
After unlocking the weatherstrip slide the tool up and
completely around the weatherstrip to unlock the lip.
(5)
Loosen the weatherstrip from the rear window
using a fibre wedge.
(6) With an assistant supporting the glass on the
outside, remove the glass by pushing from the inside.
(7)
Use of gloves will protect the hands against
possible sharp edges.
Installation Wig.
7 46)
tion.
(1)
Lubricate the glass groove with the soap solu-
GLASS
I
WEATHERSTRIP
\
Fig. 746-Rear Window Installation
IA R
Models)
(2) Position the glass at the lower outside corners.
(3) Work the lip of the weatherstrip over the glass
along the lower edge.
After the glass is centered along the top and the
lower corners, work the lip of the weatherstrip over
the lower edge of the glass.
Make sure the glass is properly seated by tapping
the glass with the palm of the hand.
NOTE: Do
not use a rubber mallet when installing
the rear window glass.
(4)
Lay a bead of sealer in the glass groove all
around the rear window.
(5)
Brush the soap solution on the locking strip.
(6) Starting at the center of the upper edge, lock
the top edge and the sides. Lock the lower edge last.
(7) Lubricate the upper groove in weatherstrip with
MYLAR STRIP
NK1164
MYLAR STRIP
NK1164
Fig. 747-Rear Window Replacement
IAV Models)