Advertisement
23-50
GLASS
(2) Insert the roller assemblies (Fig. 108) into the
slots of the glass lower frame with the spring loops
down on the top rollers and up on the bottom rollers.
(3) Insert the glass assembly into the door, position-
ing the rollers on the lower frame onto the front and
rear roller tracks.
(4)
Lower the glass to the regulator arms and in-
sert a roller into each arm stud roller slot in the
lower frame.
(5) Insert the regulator studs into the rollers and
install the spring nuts.
(6)
Lower the glass and install the down stop.
(7) Operate the window and make the necessary ad-
(8) Install the water shield, trim panel and inside
justments for alignment and ease of operation.
handles.
Regulator Assembly IAP Models)
The regulators are attached to the door inner panel
by screw and washer assemblies (Fig. 109). Spring
nuts (Fig. 108) attach the regulator arm studs to the
door glass lower frame and roller assembly. Lubri-
cate the tooth contact area approximately
Y 2
inch
wide along the entire length of the area on the out-
board side of the sector and studs on the front and
rear arms (Fig. 109).
Front Track Assembly
Removal IAP Models)
(1) Remove the door glass assembly.
(2) Remove the nut and washers attaching the
track assembly to the lower part of the door inside
panel (Fig. 72).
(3) Remove the screw and washer assembly attach-
ing the track at the belt line.
(4)
Remove the track assembly through the large
access opening in the door inner panel.
(5) Remove the center support assembly from the
track.
Installation
(1) Install the center support bracket to the plate
of the track (Fig.
110).
Fig. 109-Rear
Door Regulator-Hard
l o p
CREW
/ 11
AND WASHER
Fig. 1 1 &Rear
Door Glass Front lrack-
Hard
lop
(2) Position the track assembly into the door,
through the large access opening, and position the top
end to the attaching slot in the belt reinforcement.
(3) Install the screw and washer assembly but do
not tighten.
(4)
Insert the stud on the bottom of the track
through the attaching hole in the inside door panel
and install the nut and washers finger tight only.
(5) Install the door glass and adjust
as
necessary.
(6)
Install the water shield, trim panel and inside
handles.
Rear Track Assembly
Removal IAP Models)
(1) Remove the door glass assembly.
(2)
Remove the screw and washer assembly attach-
ing the lower part of the track to the door. Remove
the
door lock wiring clip if used (Fig. 111).
(3) Remove the adjusting sleeve nut from the stud
NK930
Fig. 1 1 1-Rear
Door Glass Rear lrack-
Hard
l o p
Hide quick links:
Advertisement
