Advertisement
9-8
E N G I N E M - C Y L I N D E R
and attach a chain hoist to the fixture eyebolt.
(2)
Lower the engine into the engine compartment
until the front of the engine is positioned on the front
engine mounts.
(3) Install the front engine mount bolts.
Do not
tighten.
(4) Install the engine support fixture Tool C-3806.
(5) Remove the chain hoist and engine lifting fix-
(6) Raise the vehicle on a hoist.
(7)
Position the rear of engine and install the trans-
(8) Install the engine rear support crossmember.
(9)
Connect the propeller shaft at the transmission.
(10) Xnstall the speedometer cable and gear shift
(11) Install the clutch torque shaft, brake cables
(12) Install the cooler lines, and transmission filler
(13) Lower the vehicle.
(14) Tighten the front engine mount bolts to
85
(15) Connect the exhaust pipe at the manifold
us-
(16) Connect the fuel lines, carburetor linkage and
(17) Install the closed vent system on the cylinder
ture.
mission.
rods.
and rods.
tube.
foot-pounds torque.
ing a new gasket.
wiring to the engine.
DOWEL HOLE
\
COOLANT PASSAGES
head cover.
retor air cleaner.
(18)
Install the radiator hoses, battery and carbu-
(19) Fill the cooling system and the transmission.
(20) Install the hood. Refer to the scribe lines made
at removal.
CYLINDER HEAD
The chrome alloy cast iron cylinder head, as shown
in Figure
8
is held in place by 14 bolts. The spark
plugs are located at the wide edge of the combustion
chambers and aluminum spark plug tubes serve as
spark plug gaskets.
Removul
(1) Drain the cooling system.
(2)
Remove the carburetor air cleaner and fuel line.
(3) Disconnect the accelerator linkage.
(4) Remove the vacuum control tube at the carbu-
( 5 )
Disconnect the spark plug wires by pulling
(6)
Disconnect the heater hose and clamp holding
(7)
Disconnect the heat indicator sending unit wire.
(8)
Disconnect the exhaust pipe at the exhaust
(9) Remove the intake and exhaust manifold and
retor and distributor.
straight out in line with the plug.
the bypass hose.
manifold flange.
FRONT
7
\
I\
OIL FEED HOLE
INTAKE VALVES
NY129
EXHAUSTVALVES
Fig.
8-Cylinder
Head
Hide quick links:
Advertisement
