Advertisement
21 -4
TRANSMISSIONQ-SPEED
MANUAL-
1ST
AND REVERSE LEVER
\ \
%/-
2ND AND 3RD
1ST AND REVERSE
LEVER PIN
SHlNG SCREW
CROSSOVER BLAD
I
I
WEDGE
O R TOOL
Fig. &Gearshift
Lever Adjustmeni
(5) Slide the clamp and swivel (on the end of the
1st and reverse control rod) either
in
or
out,
until the
swivel stub shaft enters the hole in the transmission
lever (Fig.
5
or
6).
Install washers and clip to secure.
Determine the mid back-lash position in the linkage,
then tighten the control rod lock nut.
(6)
Remove the positioning wedge
or tool from the
cross-over blade and lever, then move the selector
Iever through all positions to check adjustments and
to insure cross-over smoothness.
STEERING COLUMN AND GEARSHIFT
Removal
ative terminal.
(1) Disconnect the battery cable at the battery neg-
2ND. AND 3RD. CONTROL ROD
Fig. 5-A-903,
A-745 Gearshift Controls
I A V - I , AV-2 Models1
.
AND REVERSE CONTROL ROD
NK313
Fig. 6-A-903,
A-745 Gearshift Controls
I A P - I , AP-2, A R - I , AR-2 Modeld
(2)
Disconnect the shift linkage rods from the shift
tube levers at the bottom of the steering column
as-
sembly.
(3) Remove the steering shaft coupling to worm-
shaft clamp bolt.
(4)
Disconnect the turn signal, and horn wires.
(5) AVl, AV2 Models:
Remove horn button by in-
serting a small screw driver into steering wheel slot
at edge of the horn button. Pry the horn button and
retaining "0" ring out of the steering wheel.
APl, ARl, AP2, AR2 Models:
Turn the horn but-
ton
%
turn counter-clockwise and lift it out of the
steering wheel. To remove the Deluxe horn ring orna-
ment, remove two screws from the underside of the
steering wheel.
(6)
Remove the horn switch retaining screws.
(7)
Disconnect the horn wire clip and remove the
(8)
Remove the steering wheel retaining nut and
(9) Remove the steering wheel, using puller Tool
(10) Disconnect the steering column at the instru-
ment panel bracket by removing the retaining screws
and clamp.
(11) Remove the floor plate to toe board attaching
screws.
(12) Lift the steering column assembly up and
off
the end of the wormshaft, and remove the assembly
out through the passenger compartment being care-
ful not to soil or damage the headlining.
horn switch assembly.
washer.
C-3428.
Disassembly
ded bench to protect the paint finish.
and remove the lever.
Place the steering column assembly on a clean pad-
(1) Remove the turn signal lever retaining screw
(2)
Remove the three recessed head switch retain-
Hide quick links:
Advertisement
