Plymouth Valiant V-100 1965 Service – Technical Manual page 154

8-1 0
STARTING MOTOR-REDUCTION GEAR
POST
N K72
Fig. &Unwinding or Winding the
Solenoid l e a d Wire
starter brush terminal, contact and brushes
is
serv-
iced as an assembly.
(6) Remove all old sealer at the brush holder plate
(7)
Unsolder the solenoid lead wire and unwind the
NOTE: The
4
series coil starters do not have a wire
soldered at the brush terminal.
(8)
Remove the screw attaching the brush holder
plate to the starter gear housing (Fig. 5).
(9)
Remove the nut
(11/32tt
wrench), steel washer and
insulating washer from the solenoid terminal.
(10) Straighten the solenoid wire and remove the
brush holder plate with the brushes as an assembly.
(11)
Remove the solenoid assembly from the gear
housing well (Fig. 6 ) .
(12) Remove the nut, steel washer and the sealing
washer from the starter battery terminal.
and gear housing.
wire from the starter brush terminal (Fig. 4).
BRUSH HOLDER
INSULATOR
PLATE SCREW
\
BRUSH
T E = M l N AL
iRMlNAL
62x200A
I
Fig. 5-Removing or Installing Brush Holder
Plate Screw
ID RELAY STUD
SOLENOID LEAD
,VAPOR BARRIER
SLEEVE
SOLENOID LEAD
.ENOID RELAY STUD
/
,VAPOR BARRIER
b
ASLEE
SOLENOID COIL
I
Fig. &Solenoid Assembly Removed
STARTER GEAR
HOUSING
I
I
Fig. 7-Removing the Dust Cover
(13) Remove the starter battery terminal from the
(14) Remove the solenoid contact and plunger from
holder plate.
the solenoid.
Fig. 8-Rkmoving the Driven Gear Snap Ring