Advertisement
21 -20
TRANSMISSIONA-SPEED MANUAL
(4)
Adjust the length of the three shift rods, by
turning the swivels either
in
or
out
until the swivel
stub shafts match the control rod lever holes (Trans-
mission shift operating levers must be in the neutral
detent position during this adjustment.) Install the
swivel stub shafts and secure with the flat washers
and spring clip retainers.
(5)
Remove the lever aligning tool.
(6) With the transmission hand shift lever in the
third
or
fourth speed detent position, adjust the lever
stop screw (front and
rear)
to provide from .020 to
.040 inch clearance between the lever and the stops.
When this adjustment has been made, tighten the ad-
justing screw locknuts securely.
(7) Inspect
the linkage for ease of shifting into all
gears and for smoothness of crossover and handshift
lever clearances.
CAUTION:
Because there is no reverse gear inter-
lock, it is very important that the transmission
linkage adjustments are correctly performed in
order to prevent the possibility of engagement into
two gears at the same time.
M A J O R SERVICING
A-833
Removal
To remove the transmission on the 121Y2 inch
wheelbase Plymouth Station Wagons, it will be neces-
sary
to
first
remove the torsion bar rear anchor cross-
(8) Slide the boot down the shift lever shaft to
the floor pan and secure with attaching screws.
REAR OIL SEAL
Removal
(1) Disconnect the propeller shaft at the transmis-
sion flange and secure the shaft to the frame mem-
ber for working clearance.
(2) Hold the mainshaft with Tool (2-3281, then
r e
move the flange nut and washer.
(3) Remove the transmission flange, using Tool
C-452
if
necessary.
(4) Remove the oil seal, using Tool C-478.
Installation
ing Tool C-3837.
Tighten nut to 175 foot-pounds torque.
flange nuts to 30 foot-pounds torque.
(1) Drive a new seal into
the extension housing, us-
(2) Install the transmission flange, washer and nut.
(3) Reconnect the propeller shaft and tighten the
4-SPEED M A N U A L
GEARSHIFT HOUSING
I
M A I N DRIVE PINION
member and rubber isolators. Refer to Group
2,
"Tor-
sion Bar Rubber Isolator" for procedures, then
re-
move the transmission as follows:
(1) Remove the console trim plate. Remove shift
lever boot screws and slide the boot
up
on the lever.
EXTENSION HOUSING
COMPANION
FLANGE
BACK-UP LIGHT SWITCH
OPERATING LEVER
REPAIR STAND
VERSE OPERATING LEVER
64
x
738
Fig. 3%A-833
Transmission in Repair Stand
Hide quick links:
Advertisement
