Advertisement
GLASS
23-55
Fig. 1 1 9 4 u a r t e r Window Front lrack-
Hard l o p IAP Models)
(3) Remove the retainers and washers from the
(4)
Remove the regulator attaching screws and
(5)
Remove the regulator down out of the quarter
regulator arm studs.
disengage the pivot arm from the pivot slide.
panel.
Installation
(1) Place the regulator up into position and install
(2) Install the regulator attaching screws.
(3) Insert the regulator arms into the lower frame
(4)
Test the operation of the regulator and adjust
( 5 )
Install the water shield, trim panel, arm rest,
the pivot arm in the pivot slide.
runs and install the washers and retainers.
the glass
as
necessary.
escutcheon and handle, seat back and seat cushion.
I
I
BRACE
EW
AND WASHER
A -
Fig. 12O-Quarter Window Front lrack
Brace-
Hard
l o p
IAP Models)
Fig. 1 2 1 4 u a r t e r Window Rear lrack-
Hard l o p IAP Models)
(AV Modelsl
The procedures for the quarter window regulator
on hard top models is the same as those for the sedan
models.
Front Track Assembly
Removal (AP Models)
(1)
Remove the regulator handle, trim panel and
watershield.
(2) Remove the nut and washers attaching the track
to the belt line (Fig. 119).
(3) Remove the nut and washers attaching the track
brace to the stud on the track (Fig. 120) and the
screw and washer assemblies attaching the brace to
the inside panel.
(4)
Remove the track roller assembly from the slot
in the glass lower frame.
(5)
Slide the track assembly down off of the roller
assembly on the glass lower frame and out through
the large access opening in the door.
(6)
Remove the track support assembly.
Installation
cessive wear.
(1) Inspect the roller assemblies for damage or ex-
(2)
Install the support on the track assembly.
(3) Insert the track assembly into the door and en-
gage the top of the track into the roller assembly
on the glass lower frame.
(4)
Assemble the bracket and roller assembly to the
bottom of the track and slide the roller up the track
and insert into the slot on the glass lower frame.
(5)
Insert the track upper stud into the slot at the
belt line and install the nut and washers.
(6) Position the brace on the inside panel attaching
holes and install the screw and washer assemblies.
(7) Insert the lower stud, on the track, through the
hole in the brace and install the nut and washers.
(8)
Operate the window and adjust for alignment
and ease of operation.
Hide quick links:
Advertisement
