Plymouth Valiant V-100 1965 Service – Technical Manual page 439

Fig. 2-Steering

Gear Housing

fSectional View)

column assembly up far enough to disengage the cou-

pling from the wormshaft.

(3) Disconnect the two hoses at the control valve.

On AV2 models raise the vehicle and remove

the left front engine mount stud nut and washer. Use

a suitable jack and raise the engine slightly to provide

clearance between the left exhaust manifold and the

body sheet metal to allow removal of the gear.

Remove the starting motor.

(6) Remove the steering arm retaining nut and re-

move the steering arm from the cross shaft with

puller, Tool (2-3646.

Remove the three gear housing mounting bolts

and remove the gear from under the vehicle.

GEAR RECONDITIONING

Clean the gear assembly thoroughly in a suitable

solvent and install unit in holding fixture Tool C-3323.

(1) Drain the steering gear through

and return connections by turning the steering worm-

shaft from one extreme of travel to the other.

Remove the valve body attaching screws, and

Fig. 3-Removing

the Steering Gear Arm

Fig. 4-Removing

the Steering Valve Assembly

Fig. 5-Removing

the Pivot lever

Fig. +Removing

the Gear Shaft Cover

Retaining Nut

Show Quick Links