Advertisement
21 -56
TRANSMISSION-TORQUEFLITE
GEARSHIFT UNIT
Fig. 22-Removing
or Installing Console
I A P - l , A P - 2 , A R - I , AR-2 Models)
the horn button.
(10) Connect the turn signal, gearshift indicator
light and horn wires. Connect the battery ground ca-
ble,
test the operation of the lights and horns.
(11) Connect and adjust the gearshift control ca-
ble and parking lock cable. Refer to Pages
57
and
58.
CONSOLE GEARSHIFT UNIT
Removal
the battery.
(1) Disconnect the negative (ground) cable from
Fig. 23-Removing
or Installing Console
IAV-
I ,
AV-2 Models)
MOUNTING LEGS
(4)
1
ACK-UP LAMP SWITCH
I
GEARSHIFT
ONTROL CABLE N K 147
Fig. 24-Console
Gearshift Unit
NOTE:
If the gearshift and/or parking lock cables
are to
be
replaced, disconnect them from the trans-
mission. Refer to Pages
57 and 58.
(2)
Remove the set screw from the gearshift lever
knob and remove the knob.
(3) AP-1, AP-2, AR-1, AR-2
Models:
Remove the
screws from the rear end of the console upper fin-
ish plate (Fig. 22). Raise the rear end of the plate and
work it rearward to disengage it from the front of the
console. Lift the plate upward far enough to remove
the dial lamp and socket, then lift off the plate. Re-
move the four gearshift unit to console retaining bolts.
Raise the console lid, remove two screws from
bottom of the tray, securing console to the floor rear
mounting bracket.
Carefully raise the lower edge of the console side
trim and loosen the console-to-floor bracket mounting
bolts (two bolts on each side of console). Loosen the
bolts several turns but do not remove.
Disconnect the courtesy lamp wires and any other
electrical connections, then lift
off the console as-
sembly.
(4) AV-1, AV-2 Models:
Remove four screws secur-
ing the console to the floor mounting brackets (Fig.
23).
Lift the console upward far enough to remove the
dial lamp and socket, then lift
off the console assem-
bly. Remove the four gearshift unit to floor bracket
retaining bolts.
(5)
Disconnect the two cable and housings from
the unit. Disconnect the back-up lamp switch wires
(Fig.
24).
(6)
Attach a piece of soft wire about four feet long
to the end of each cable. Coat the cable housings
with lubricant, then carefully pull the cable assemblies
down through the floor grommets. Disconnect and
leave the wires in the floor to route the cables during
reinstallation.
Hide quick links:
Advertisement
