Advertisement
23-20
INTERIOR T R I M AND SEATS
Fig. 3 6 - R e a r Compartment Security Panel
fAVP29 Models)
(6)
Position the listing wire up to the spring ele-
ments and starting from the center, use hog rings
and attach the new cover to each spring element.
Work alternately toward each corner.
(7)
After the new cover has been completely at-
tached, turn the cushion right side up and inspect
for wrinkles. Work out all wrinkles as necessary.
Rem Seat
Back
and Panel
fAVP29 Models)
The rear seat back and panel is attached to the in-
ner panel wheelhouse by use of a pivot bracket and
seat hinge (Fig. 35). The back assembly is adjustable
at the four hinge to back panel screws.
The release bar handle is attached to the back pan-
el by screws at side mounting bracket. The release
bar handle is also used in conjunction with the hold
down straps in keeping the back panel locked in a
down position.
FOLDED BOX
Fig. 37-Assembling
Glove B o x IAR Models)
I
4
MOLDED B O X 1
(
3
&
NK815
Fig. 38-Glove
B o x Assembly
IAV Models)
REAR COMPARTMENT SECURITY PANEL
fAVP29 Models Only)
The rear compartment security panel (Fig. 36) is
attached to a hinge at the lower edge which in turn
is attached to the rear of the center floor pan. The
security panel is retained at the top edges by locks
and striker plates (Fig. 36).
G L O V E BOX
The glove box used on AP and AR Models is a
folded type box that is stapled together (Fig.
37)
while the glove box on AV Models is a molded type
(Fig. 38). The front edges of the AR Model glove box
fit between the glove box opening frame and the in-
strument panel. On AV Models, the glove box is in-
serted flush with the opening.
Door, Handle and Lock Replacement
door, handle and lock assembly.
Refer to Figure 39 for the attaching points
of
the
SCREW
CATCH
\
NK813
B
Fig. 39-Glove
B o x Handle,
Door
and Lock
fAR Models)
Hide quick links:
Advertisement
