Plymouth Valiant V-100 1965 Service – Technical Manual page 618

23-48 GLASS
arm bushing into the glass.
(2) Position the glass into the door and position the
rear regulator arm into the glass lift bracket chan-
nel.
(3) Position the regulator front arm pivot through
the bushing, in the glass, and install the retainer clip.
(4)
Position the glass in the division bar channel
and the rear channel.
(5) Adjust the door glass and install the up stops.
(6) Install the water shield, door interior trim and
hardware.
Regulator Assembly
fAP Models)
The service procedures for the front door regulator
and vent wing regulator assembly are the same as
those for the sedan models.
fAR Models)
is the same as those for the sedan models.
fAV Models)
The two-arm regulator used on hardtop models (Fig.
104), is attached to a nylon-bushed hole at the front
of the glass. The lift bracket, toward the rear of the
glass, is attached to the glass with a plastic rivet.
For a good engagement of the glass in the division
channel run, shift the regulator assembly forward. It
is important that the glass seat fully in the division
channel. Alignment of the front edge of the glass with
the division channel is also important. Shift the rear
of the regulator assembly up or down to level the glass
and align it with the division channel.
Glass Run Channel fTwo Door Models)
Removal fAP Models)
ter
shield.
The service procedures for the front door regulator
(1)
Remove the inside handles, trim panel and wa-
cusv
VIEW IN DIRECTION OF ARROW
64
x
375
Fig. 1 O L Y a r d lop
Door
Glass
Regulator
IAV Models]
SCREW AND WASHER
SCREW AND WASHER
SUPPORT NK918
Fig.
1 OS-GIass
Run Channel-2 Door
IAP Models)
(2)
Loosen the vent attaching screws and adjusting
stud nut and move the glass forward out of the glass
run channel.
(3) Remove the
run
channel reinforcement plate
and the screw and washer assembly from the upper
end of the run channel door face (Fig. 105).
(4) Disengage the support on the bottom of the
channel from the door panel.
(5) Remove the channel from the door assembly.
lnstallatian
(1)
Position the run channel and support into the
door assembly and install the upper attaching screw
at the door face (Fig. 105).
(2)
Position the support at the bottom of the chan-
nel to the inside panel and insert the tab into the slot.
(3) Install the reinforcement plate at the lower end
of the
run
channel.
1
SCkEW
WASHER AND WASHER
Fig. 106-Class Run C h a n n e U Door
IAP Models)