Plymouth Valiant V-100 1965 Service – Technical Manual page 339

14-8 CARBURETOR-HOLLEY
BOWL VENT VALVE.
kW.
,
BOWL VENT ROD
\
ECONOMIZER
--.
CHOKE
VACUUM
64x292
Fig. &Removing or Installing Bowl Vent Rod
ECONOMIZER
VACUUM HOLE
CLOSED CRANKCASE
VENT TUBE FITTING
Fig. 5-Removing or Installing the Economizer
64x293
BAFFLE
FLOAT 64x294
Fig. &Removing or Installing Fuel Bowl
MAIN
J 6
f '
64x295
Fig. 7-Removing or Installing Economizer Body
dle valve and seat.
(6) Remove the economizer retaining screws, then
lift economizer cover, diaphragm and stem out of the
carburetor, as shown in (Fig. 5).
(7)
Remove the fuel bowl attaching screws, then
remove the fuel bowl, baffle and gasket, as shown in
(Fig. 6). Slide baffle out of bowl. Discard the gasket.
Remove the float bumper spring.
(8)
Using a suitable tool, remove the float retain-
ing clip, then slide float
off
the fulcrum pin.
(9) Remove the screws that attach the economizer
body and plugs, then remove the economizer body as
shown in (Fig.
7).
(10) Tilt the pump lever on its pivot until the hook
on the pump diaphragm stem can be released. Slide
the pump diaphragm and spring out of the fuel bowl.
Refer to (Fig.
8).
(11) Using Tool
(2-3748,
remove the main jet from
the economizer body. See (Fig. 9).
(12) Using a suitable tool, remove the pump lever
retaining clip. Slide lever off pivot and disengage link
from throttle lever.
SPRING
PUMP DIAPHRAGM
PUMP DIAPHRAGM S T E M
64x 296
Fig. 8-Pump Diaphragm and Spring