Plymouth Valiant V-100 1965 Service – Technical Manual page 297

9-40 ENGINES-8-CYLINDER
CREW
(TOOL)
<
-CHAIN CASE COVER
v
k a a r i v i u r
I
KR154
% /
' r '
Fig. 91-Positioning Installer Plate on
N e w Seal Tool C-3506
the blocks into the gap to a point of distorting the seal
retainer lip (Fig. 89). This is important (puller is only
positioned at this point).
(3) Place the sleeve over the retainer and place re-
moving and installing plate into sleeve.
(4)
Place the flat washer and nut on puller screw.
Hold the center screw and tighten the lock nut to re-
move the seal (Fig. 90).
Installation of
Oil
Seal
(1) Insert the puller screw through the removing
and installing plate so that the thin shoulder will be
facing up.
(2) Insert the puller screw with plate through the
seal opening (inside of chain case cover facing up).
(3) Place the seal in the cover opening, with neo-
prene down. Place the seal installing plate into the
new seal, with protective recess toward lip of seal
re-
tainer (Fig. 91).
PULLER SCREW ( T O O L ) a
m
a
LATE
\-GEAR CASE COVER
RETAINE
R
KR155 A
Fig. 92-Installing New Seal Tool C-3506
Fig. 93-Measuring Seal for Proper Seating
NOTE:
Lip of the neoprene seal must
be
toward
the source of oil.
(4)
Install the flat washer and nut on puller screw,
hold screw and tighten the nut (Fig. 92).
( 5 )
The seal is properly installed when neoprene is
tight against the face of the cover. Try to insert a
.0015 feeler gauge between the neoprene and the cov-
er (Fig. 93). If this seal is installed properly, the feel-
er gauge cannot be inserted. It is normal to find par-
ticles of neoprene collected between the seal retainer
and crankshaft oil slinger after the seal has been in
operation.
Installing Chain Case Cover
(1) Be sure the mating surfaces of the chain case
cover and cylinder block are clean and free from
burrs.
(2) Using a new gasket slide the chain case cover
over the locating dowels and tighten bolts to 15 foot-
pounds torque. Use extreme caution to avoid damag-
ing the oil pan gasket.
(3) On 273 and 318 Cubic Inch Engines, install the
fuel pump lines and fuel pump.
CHAIN CASE COVER
TIMING INDICATOR
CYLINDER BLOCK
TIMING MARK
IBRATION DAMPER
KR157A
Fig. 94-Installing Vibration Damper Assembly
1001 C-3688