Plymouth Valiant V-100 1965 Service – Technical Manual page 610

23-40 GLASS
(6) Align and install the front arm stud into the
(7)
Install the trim panel and hardware.
bushing and secure with the clip.
IAP ModelsJ Regulator Replacement
The regulator assembly (Fig.
84)
is attached to the
quarter inner panel with three screw and washer as-
semblies. The roller assemblies on the regulator top
arms engage the channels of the glass lift brack-
ets. The lower regulator arm roller engages the glass
pivot bracket and channel assembly. Apply lubricant
to the tooth contact area approximately
V 2
inch wide
along the entire length of the area on the outboard
side of the sector (Fig.
84).
Removal IAR-AV Models)
(1)
Remove the seat cushion, seat back, arm rest,
handles and escutcheon, trim panel and water shield.
(2)
Prop the window in the up position.
(3) Remove the retainers and washers from the
regulator arm studs.
(4)
Remove the regulator attaching screws (Figs.
85
and
86)
and disengage the pivot arm from the pivot
slide.
( 5 )
Remove the regulator down out of the quarter
panel.
Installation
the pivot arm in the pivot slide.
(1)
Place the regulator up into position and install
(2) Install the regulator attaching screws.
(3) Insert the regulator arms into the lower frame
(4)
Test the operation of the regulator and adjust
(5)
Install the water shield, trim panel, arm rest,
runs
and install the washers and retainers.
the glass as necessary.
escutcheon and handle, seat back and seat cushion.
LOWER FRAME
FRONT TRACK
Fig. 85-Regulator Assembly IAR Models)
Fig. 86-Regulator Assembly fAV Models)
Quarter
Glass
Run
Removal
IAP
Models)
(1)
Remove the quarter glass assembly.
(2) Remove the glass run from the rear run
re-
tainer (Fig.
87)
and from the channel between the
in-
side and outside panels. The run is press fit into the
channel and lower run retainer.
(3)
Remove the screw attaching the rear run retain-
er to the window opening frame and drain trough.
(4)
Remove the screw and washer attaching the rear
run retainer support to the support bracket.
(5)
Remove the run retainer through the large ac-
cess opening in the inner panel.
Installation
(1) Position the glass run retainer into the quarter
panel aligning the support to the rear of the support
bracket.
(2) Install the support to support bracket screw
loosely.
Fig. 8 7 4 u o r l e r Glass Run and Retainer
IAP Models)