Advertisement
ALIGNMENT, HOOD-FENDER
AND DOORS
23-27
NK878
Fig. 51-Door
Lock Assembly IAP Modelsl
(4)
Disconnect the lock control rod from the lock
assembly.
(5)
Remove the screws attaching the lock assem-
bly to the door.
(6)
Rotate the lock assembly and disconnect the re-
mote control link when removing the lock.
(7)
Lubricate all moving points of the lock assem-
bly.
(8)
Position the lock assembly in the door and con-
nect the remote control link to the lock.
(9) Install the lock retaining screws.
(10) Connect the handle to lock link.
(11) Connect the locking lever rod (front door only)
(12) Connect the locking lever rod and the remote
to the lock assembly.
control link to the lock.
v
VIEW "A"
CONTROL & LINK
(13) Test the operation of the lock assembly
(14) Install the water shield.
(15) Install the door trim and hardware.
Door Lock Cylinder
Removul
(1) Remove the inside handles, trim panel and
wa-
tershield.
(2)
Using a screwdriver through the access hole of
the door panel pry the "U" shaped retainer (Fig. 52)
off of the back of the lock cylinder.
(3) Withdraw the lock cylinder part way out of the
door panel and with a rotating motion of the lock
cylinder body, disengage the lock cylinder arm from
the link.
Installation
(1) Hold the lock cylinder link in alignment with
the lock cylinder hole in the door outer panel.
(2) Engage the hole of the lock cylinder arm with
the link and rotate the lock cylinder until the link is
locked in place.
(3) Enter the lock cylinder into place and install
the "U" shaped retainer into the grooves of the lock
cylinder.
(4) Install the water shield, trim panel and inside
handles.
REMOTE CONTROL ASSEMBLIES
The door remote control assemblies are attached
to the door inner panels with two screws. The units
MK876
Fig. 52-Door
lock Cylinder
NK875
Fig. 53-Deck
l i d Hinges IAP Modelsl
Hide quick links:
Advertisement
