Advertisement
23-42
GLASS
Fig. 91-Rear
Door Glass Replacement
(Sedan-"
P Models)
Glass Replacement fAP Models)
(1) Remove the door inside handles, trim panel and
watershield.
(2) Remove the spring nut (Fig. 91) securing the
rear arm of the regulator to the glass lower frame.
(3) Remove the regulator arm stud from the roller
in the lower glass frame and remove the roller.
(4)
Rotate the glass rearward (Fig. 91) and disen-
gage the slot of the lower glass frame from the roll-
er on
the front regulator arm.
(5)
Remove the glass and frame assembly from the
door.
(6) Before installing the glass and frame assembly,
lubricate the roller areas of the frame. The rollers
should be inspected for damage or excessive wear.
Glass
Lower Frame Attachment
The rear door glass lower frame (Fig. 92) is attached
RIVET
2
Fig. 92-Rear
Door Glass Attachment
(Sedan-AP
Models)
NK901
~
~~~~~~
~~~
~
to the glass with plastic rivets. Gaskets are used be-
tween the frame and glass. Lubricate the roller areas
of the frame before installing.
Removal
fAR
Models)
inside door hardware.
(1)
Remove the rear door arm rest, trim panel and
(2) Remove the door water shield.
(3) Lower the window and disconnect the regula-
(4)
Remove the door glass upper stop.
(5)
To remove the door glass, it is necessary to piv-
ot the glass upward at the front end of the glass to
free it from the glass run channels.
(6) After the door glass is free of the glass run
channels, pull the glass up and out of the door open-
ing.
Installation
(1) Slide the door glass down into the door, rear
portion of glass first, and position the glass into the
glass run channels as it is pivoted into place.
(2)
Connect the regulator arms to the glass chan-
nels.
(3) Lubricate the regulator roller area on the glass
channel with lubriplate.
(4)
Install the door glass upper stop.
(5)
Operate the door glass and test
for
ease of
op-
(6)
Adjust the door glass.
(7)
Install the water shield, trim panel and inside
tor arms from the glass channel.
eration and for correct alignment.
door hardware.
Removal
fAV
Models)
water shield.
90) and remove the glass from the run channels.
channel.
(1)
Remove the door interior trim, hardware and
(2)
Loosen the window track adjusting nuts (Fig.
(3) Remove the regulator arm from the lift bracket
(4)
Remove the glass from the door.
(5)
Remove the lift bracket from the glass (Figs.
74
and
75).
Installation
parts of the regulator with lubriplate.
Before installing the glass, lubricate all moving
(1)
Install the lift bracket on the glass.
(2)
Position the glass into the door opening.
(3)
Install the regulator arm roller into the chan-
nel of the glass lift bracket.
(4)
Position the glass into the run channels.
(5)
Adjust the door glass.
(6)
Install the water shield, door interior trim and
hardware.
Regulator Assembly Replacement fAP Models)
The regulator (Fig. 93) is attached to the door in-
Hide quick links:
Advertisement
