Plymouth Valiant V-100 1965 Service – Technical Manual page 24

Fig. 37-Apply

Choke Shaft Ends

Fig. 35-Cleaning

Filter Element

OIL BATH TYPE (Extra Equipment)

The oil level in the cleaner (Fig. 36) should be in-

spected and the cleaner thoroughly cleaned in accord-

ance with the Certified Car Care Schedule. The sedi-

ment in the oil reservoir should not be permitted to

build up beyond a point Ys inch below the ledge.

To clean, remove the cover and filter element as-

sembly, rinse thoroughly in kerosene and drain. Emp-

ty the old oil from the reservoir, clean it thoroughly

and refill to the indicated level with SAE 1OW-30 en-

gine oil. This grade of oil is suitable for all tempera-

Reassemble the cleaner and install on carburetor.

CABURETOR CHOKE SHAFT RND LINKAGE

Gum deposits on the choke shaft bearings may be

removed by applying Carburetor Cleaner, Part Num-

Fig. 36-Carburetor Air Cleaner [Oil Bath Type)

Fig. 38-Fuel

F i l t e r 4 - C y l .

ber 1643273, to assure freedom of movement of the

choke shaft and linkage.

With the air cleaner removed, apply the cleaner to

the ends of the choke shaft where it rotates in the

air horn (Fig. 37). At the same time, move the choke

shaft back and forth until the deposits are flushed

Run the engine at idle to clean out any excess

cleaner from the carburetor and intake manifold.

Fig. 39-Fuel

Cu. In. Engine

Show Quick Links