Advertisement
23-38
GLASS
Fig. 7 9 4 u a r f e r Glass Adjusting Points-
IAV Models)
methods of adjustment for the quarter glass.
IAV
Models)
The regulator assembly (Fig.
79)
can be adjusted
fore or aft. This moves the glass fore or aft to get
a good fit or engagement of the glass in the front
glass run.
The rear of the regulator can be adjusted up or
down to square up the glass in the opening. It is
important to adjust the regulator position to obtain
full, uniform engagement of the leading edge of the
glass in the front glass run.
The lower end of the front glass run channel should
be adjusted in or out so the entire front run forms a
straight line from top to bottom. This can be per-
formed if the glass is lowered halfway so the glass
lines up with the upper and lower sections of the front
run.
The lower end of the rear glass run channel should
GI A S S
,1155
Fig. 8O-Quarfer Glass Attachment IAP Models)
FRONT OF CAR
NK1154
Fig. 8 I 4 u a r t e r Glass Lift Bracket
IAP
Models)
be adjusted forward, while the glass is fully lowered,
to remove looseness. An in-or-out adjustment is also
provided at the lower end of the rear run channel
Quarter Window Glass Replacement
Removal
IAP
Models)
(1)
Remove the rear seat cushion and back.
(2) Remove the quarter window regulator handle.
(3) Remove the quarter trim panel and water shield.
(4)
Disengage the regulator arm from the lift
bracket.
( 5 )
Tilt the front top edge of the glass up (Fig.
80)
and pull the glass upward disengaging the rear lift
bracket from the regulator arm.
(6)
Remove the glass assembly from the quarter
panel.
Glass Lift Bracket
The glass lift brackets (Fig. 81) are attached to the
glass with plastic rivets. Gaskets are used between
the glass and the brackets. Lubricate the channel
area of the brackets before they are installed.
Installation
To
facilitate installation of the glass, install the
rear lift bracket only, before inserting the glass into
the quarter panel.
(1) Install the rear lift bracket and gasket on the
quarter window glass.
(2)
Lower the glass assembly into the quarter panel,
with the rear edge down and the lift bracket forward.
(3) Position the rear lift bracket over the roller on
the regulator rear arm.
(4)
Rotate the front of the glass forward
so
the
glass is positioned in the
front
and rear run channels.
( 5 ) Position the front lift bracket
on
the regulator
front arm.
Hide quick links:
Advertisement
