Advertisement
19-32
STEERING
SMALL PUMP
(.96
CU.
IN.
DISPLACEMENT)
63x681
Fig. 19-Slipper
Retainer Washer Tool
CAUTION: Use care when handling the rotor and
shaft since the corners of the rotor are extremely
sharp and must remain sharp for good pump oper-
ation. The oil seal and bearing surfaces of the shaft
must remain free of any nicks and burrs.
(12) Use an ordinary wood pencil with the point
broken to install the new springs. Enter the blunt
tapered end of the pencil in the spring and snap the
springs into the pockets in the rotor by turning the
pencil clockwise (Fig.
16).
Install the springs and slip-
pers in one rotor slot at a time. Remove the pencil
from the spring with a counter-clockwise rotation. Ei-
ther end of the spring may be inserted into the rotor
pocket.
NOTE: Make sure the proper springs are installed.
The springs for the .96 (small) pump are different
than the springs for the 1.2 (large) pump.
(13)
Install each slipper by sliding the slipper be-
tween the two springs and the wire tool so that the
63x680
LARGE PUMP
(1.2
CU.
IN.
DISPLACEMENTI
Fig. 2 L S l i p p e r Retainer Washer Tool
TOOL
f
63x682
Fig. 2 1 4 n r t a l l i n g the Shaft and
Rotor Assembly
ends are flush with the rotor. The notched portion of
the slipper must be installed, Fig. 17.
NOTE: Inspect the springs to make sure they are in
the pockets and in an upright position under the
slipper (Fig. 18).
(14)
Using a washer of the dimensions shown in
Figs. 19 and
20,
drop it over the pulley end of the
shaft. This washer is used to keep the slippers flush
with the end of the rotor.
NOTE:
It is
important that the slippers remain
flush with the end of the rotor throughout the as-
sembly operation.
* 1
63x684
Fig. 22-Pressing
the Front Insert into the
Pump Housing
Hide quick links:
Advertisement
