Plymouth Valiant V-100 1965 Service – Technical Manual page 233

SIX WAY POWER SEATS a-a9
that hold the left side of the front seat to the seat
adjuster.
(2) Prop-up the left side of the seat cushion ap-
proximately six inches.
(3)
Disconnect the control switch wires from the
relay on the motor.
(4)
Remove the two nuts that attach the motor to
the drive unit.
(5) Remove the motor and rubber coupling from
the drive unit.
(6) Disconnect the motor wires from the relay.
(7) Remove the relay from the motor.
Installation
attaching screw.
(1) Position the relay on the motor and install the
(2)
Connect the motor wires to the relay.
(3) Install the motor and rubber coupling to the
drive unit. Install the two attaching nuts.
(4)
Connect the control switch wires to the relay
on the motor.
(5) Remove the prop from the left side of the seat
cushion. Position the seat on the seat adjuster and
install the two mounting stud attaching nuts.
Refer to "Removal of Flexible Cables" steps 1
through
4.
(2)
Remove the two screws holding the plate and
solenoids to the drive unit (Fig. 6).
(3) Remove the plate and solenoid assembly. Be
careful not to lose the three springs under the sole-
noid.
(4)
To remove the solenoid coils, bend back on the
tabs of the solenoid cover. Unsolder the coil mound
wire at the cover tab and remove the coil cover from
the coil.
(5)
Remove the screws holding the cover on the
drive unit.
(6)
Remove the cover and lift out the clutch lever
and shaft.
Assembly
the lever is properly seated on the collar.
(1) Install the clutch lever and shaft. Make sure
(2) Install the cover and screws.
(3)
Install the coil in the coil cover with the coil
(4)
Position the cover tabs in the slots on the coil
ground wire next to one of the cover tabs.
plate.
(5) Bend over the tabs and resolder the coil ground
(6)
Install the three solenoid spring and position
Drive Unit and Solenoid Assembly
Disassembly
wire to the tab and plate.
the solenoids over the springs.
(1) Remove the drive unit from the seat assembly.
DRIVE ASSEMBLY
R U B B E R COUPLING
COIL GROUND WIRE
KR749B
Fig. &Solenoid and Coil lDisassembled V i e w )